Scag Power Equipment STC48V-23CV

Questions and Answers

J
juancoxAug 11, 2025
How to fix streaking (strips of uncut grass) with Scag Power Equipment Lawn Mower?
- A
  Amanda ParsonsAug 11, 2025
  To address streaking (strips of uncut grass) with your Scag Power Equipment Lawn Mower, make sure to sharpen dull or worn blades, and ensure correct blade sharpening. Also, maintain full engine RPM and adjust belt tension if it's slipping. Clear any grass accumulation from under the deck. Reduce ground speed if it's too fast, cut only when the grass is dry, and replace bent blades.
C
Christy CarrollAug 17, 2025
What to do if Scag Power Equipment Lawn Mower leaves stringers (blades of uncut grass)?
- L
  lwilsonAug 17, 2025
  To resolve occasional blades of uncut grass (stringers) with your Scag Power Equipment Lawn Mower, ensure the engine runs at full RPM and reduce ground speed. Cut grass after it has dried out. Sharpen dull blades and clean any grass accumulation from the underside of the deck. Also, adjust belt tension if the belts are slipping.
M
Maria EvansAug 23, 2025
How to fix uneven cut on flat ground with Scag Power Equipment Lawn Mower?
- T
  Teresa JohnsonAug 23, 2025
  To correct an uneven cut on flat ground with your Scag Power Equipment Lawn Mower, replace blades if the lift is worn, and ensure the blade is mounted with the cutting edge toward the ground. Clean grass from under the deck and adjust the deck pitch and level. For improperly mounted decks or bent spindle areas, consult your authorized SCAG dealer. Finally, sharpen dull blades.
D
Derek GoodmanAug 29, 2025
What to do if Scag Power Equipment Lawn Mower leaves strips of uncut grass between cutting paths?
- A
  Aaron JensenAug 29, 2025
  If your Scag Power Equipment Lawn Mower is leaving strips of uncut grass between cutting paths, increase the overlap of each pass.
S
stevensonmichaelSep 4, 2025
How to fix uneven cut on uneven ground with Scag Power Equipment Lawn Mower?
- F
  frank88Sep 4, 2025
  To address an uneven cut on uneven ground with your Scag Power Equipment Lawn Mower, you may need to reduce ground speed, raise the cutting height, and/or change the direction of the cut.

Scag Power Equipment STC48V-23CV Specifications

General

Cutting Width	48 inches
Transmission	Hydro-Gear ZT-2800
Weight	1050 lbs
Turning Radius	Zero-turn
Blade Engagement	Electric PTO clutch
Engine	Kawasaki 23 hp
Deck Material	Fabricated steel