Scale House ASB30 - Set-Up Environment

10
price.
6.11 BACKLIGHT
The scale has three backlight mode: on, off and auto.
ON: backlight will turn on however current weight is zero or not zero.
OFF: backlight will turn off however current weight is zero or not zero.
AUTO: backlight will turn on when current weight is not zero and it will turn off if current weight is zero
You can press B/L key to set backlight mode, display will show current backlight mode, press SAVE key to select
backlight mode (ON/OFF/AUTO), after you select, press TARE key to sure.
6.12 AUTO POWER OFF
The scale have auto shut off function, you can set this parameter.
Press ACCOUNT key during self-checking, display shows “sleep mode”, press SAVE key to select 0/1/5/30 (not use
auto power off / turn off power after scale leisure for 1 minutes / turn off power after scale leisure for 5 minutes / turn
off power after scale leisure for 30 minutes), press TARE key to sure.
6.13 VISUALISATION WITH SENSITIVITY TIMES 10
It’s possible to use this function as a test in the calibration phase.
Keep the TARE key pressed for three seconds and release: the display will show the weight with the minimum division
times 10 (a blinking digit is added).
After about 5 seconds the display will return in the standard mode.
7. SET-UP ENVIRONMENT
The scale has various parameters that can be configured in the SET-UP environment.
To enter in the SET-UP environment press during the start-up the TARE key during the countdown.
One is asked to enter the password. The default password is 0000.
- Enter the password and press the TARE key:
- The second display will show the first function, "F0":
- Pressing the SAVE will cycle through the other functions.
- Pressing TARE will allow you to set the function.
- Use SAVE or set a value using the numeric keys,
- Press TARE key to enter the value or use the ZERO key to leave a parameter unchanged or to escape set-up
environment.