11
6. Commissioning & Operation
6.1 Leaving the bypass in ‘bypass’ mode, open the main valve (stop tap) slowly and flush
for several minutes in order to avoid any debris from installation entering the water
softener.
6.3 Now add salt into the salt container
(indicated) salt may filled to about
3/4 of the height of the salt tank.
6.2 Add water to the salt container until
the water level is approx, 10cm (4”)
high.
6.4 Turn the bypass fully 180° slowly into
“service” mode.
THE SOFTLINE 150 WILL USE EITHER GRANULES, TABLETS OR BLOCK SALT.
THE SOFTLINE 150C & 450 USED EITHER GRANULAR OR TABLET SALT.
ALWAYS USE SALT THAT HAS BEEN SPECIFICALLY FORMULATED FOR USE IN WATER
SOFTENERS. (IF IN DOUBT CONSULT YOUR SUPPLIER)
To Next Page
Loading...
