SCALEO infinity - Care Instructions

6
CARE INSTRUCTIONS
2. TURNING ON AND OFF
To turn o the lamp, there are several options that will have the following outcomes:
Turning on and o via IFC
To turn o the lamp by using the IFC, you need to push the IFC button for at least 3 seconds. The lamp will
turn o and save the current setting. To turn on the lamp, you need to push the IFC button again for at least 3
seconds.
• The light-settings are being saved during switching on and o (3 seconds pressing the button). After
reboot for example through switching o at battery canister or loose connection this settings (including
on/o state) are loaded again.
• When the lamp is turned o by using the IFC it will still consume a small amount of energy. In standby
mode the lamp consumes about 3 mA.
Turning on and o via power source
If the lamp is turned off by using the power source, e.g. by using the battery switch, the lamp will completely
shut down and the last settings will not be saved. When switched on again via the power source, the lamp will
restore the settings that where saved by switching on or off with the IFC.
To ensure that you will continue to take pleasure in your SCALEO innity, we recommend to read the following
care instructions.
• Rinse o the lamp thoroughly after every dive with clean freshwater and dry it o afterwards. Do not use
any further cleaning agents.
• Make sure to protect the dome port from shocks, sand and sharp items in order to avoid scratches.
• Before every dive make sure to check if the retaining ring and the lamp head are tightly screwed to-
gether, the cable cover sits rmly and the pressure piece of the cable cover is locked properly.
• In the event that the o-rings are visibly damaged or assumed damaged, they must be replaced by the
service of the RP-Engineering GmbH or a qualied dealer.