Scalextric digital ARC PRO - POWERBASE SETUP

12
POWERBASE SETUP -
The Powerbase MUST NOT go in the centre of the pit lane, as this will not register a lap when going through
the pit lane.
To avoid this, connect the power base in the correct position, either before or after the pit lane, when setting
up the track.
IMPORTANT
It is recommended
that the powerbase
is assembled in the
middle or at the
end of a striaght,
not directly after a
corner, as this can
result in some laps
not registering in
extreme cases.
Pit Lane Setup
Powerbase Setup