SCALIX FEJ-5000 User Manual

COMPACT SCALE/BALANCE
INSTRUCTION MANUAL
SAFETY PRECAUTIONS
All safety messages are identified by the following words "WARNING" and
"CAUTION". These words mean the following:
△WARNING
Important information to alert you to a situation
that might cause serious injury and damage to
your property if instructions are not followed.
△CAUTION
Important information that tells you how to
prevent damage to your equipment.
When using the scale/balance, the following safety precautions should always be
followed.
△ WARNING
Use only batteries or an adapter. Do not use both at the same time as this will
invalidate the warranty and damage the scale. (Only batteries are supplied
with this scale)
△ CAUTION
Avoid installing the scale/balance in direct sunlight; this may cause discoloration or
malfunctions.
Do not mix the type of batteries. Replace all batteries at the same time.
If the scale/balance is not to be used for a long period of time, remove all batteries
from the battery compartment to avoid leakage which may cause damage to the
scale.
Avoid overloading that could cause damage to the scale/balance.
Do not drop water on the scale/balance it is not water-resistant. It will damage the
inside if the scale/balance is wet.
Matter charged static electricity could influence the weighing. Discharge the static
electricity. Example, the method is to use an electrification prevention spray. Spray
it to both sides of the weighing platform.
1

SCALIX FEJ-5000 Specifications

General

Brand	SCALIX
Model	FEJ-5000
Category	Scales
Language	English

Summary

Safety Precautions

General Warning

Use only batteries or an adapter; do not use both simultaneously.

General Cautions

Follow precautions for installation, battery use, overload, water, and static electricity.

Preparation

Installing Batteries and AC Adapter

Instructions for installing batteries and connecting the AC adapter.

Scale Setup

Guidance on placing and leveling the scale for accurate operation.

Weighing Procedures

Before Weighing

Allow the balance to warm up and read calibration first.

Weighing Steps

Step-by-step guide for weighing with and without a container.

Calibration

When to Calibrate

Conditions requiring calibration, like initial setup or relocation.

How to Calibrate

Detailed steps to perform the calibration process.

Function Settings

Enter Function Setting Mode

How to enter the mode for configuring scale functions.

Auto Backlight Selection

How to enable or disable the auto backlight feature.

Auto Shut Off Selection

How to set the automatic power-off timer.

Return to Weighing Mode

How to exit function settings and return to normal weighing.