Page 13
5. OPERATION
WARNING:
DO NOT USE GASOLINE, LIGHTER FLUID, KEROSENE OR OTHER FLAMMABLE LIQUIDS
TO START OR FRESHEN A FIRE IN THIS INSERT. KEEP ALL SUCH LIQUIDS WELL AWAY
FROM THE FIREPLACE WHILE IT IS IN USE.
5.1 Fueling the fireplace
:
Your SCAN DSA wood-burning fireplace is designed for burning dry natural well-seasoned
wood only (If your wood supply is not seasoned, ask your authorized SCAN dealer where to
obtain seasoned fuel in your area). Wood should be stored in a dry place for at least one year
before being used for fuel. Some trees have very high moisture content and it is necessary to
thoroughly dry the wood. Cutting and splitting the wood can speed up the drying process, then
stacking it with both ends of the stick exposed. More drying occurs through the end than
through the sides even when the wood is split. We recommend that the moisture content of the
wood be between 15-18% on a wet basis.
Green or uncured wood does not work well as fuel, and can cause increased creosote buildups.
The value of green wood as a source of heat is limited. Do not overload, use kindling wood, or
mill ends for primary fuel as this may cause over-firing.
Although feeding excessive amounts of fuel to the insert should be avoided, it is important to
supply it with sufficient fuel to maintain a moderately hot fire (this is particularly important since
burning wood produces volatile substances).
Burning materials other than natural dry well seasoned wood may shorten the life of your insert
and possibly lead to a dangerous over-firing condition. Do not burn garbage, particleboard
scraps or pressed logs using bonding agents because they can produce conditions, which will
deteriorate metal.
Starting
a Fire:
Do not elevate the fire. Build fire directly on the hearth inside the fireplace.
5.2 Starting a Fire:
To start a fire, pull the start device to fully open the air intake control. In addition, to help with the
startup, you may also leave the fuel door slightly ajar. Use a small amount of firelighters with
enough kindling wood to establish a small brisk burning fire. Add several larger pieces of wood
on top of the burning kindling and allow enough time for it to fully catch on fire. Add a full load of
fuel and close and latch the fuel door. After five minutes, close the start device and adjust the
air intake control to the desired position.
CAUTION:
RISK OF EXCESSIVE TEMPERATURES. THE MAXIMUM TIME THE START DEVICE CAN BE
OPEN DURING STARTUP IS FIVE MINUTES! KEEP START DEVICE CLOSED DURING
FIRING OF THE HEATER
To Next Page
Loading...
