Page 8
Water Connection
Cold Water Connection
Connect the cold water supply hose to a threaded 3/4(inch) connector and make sure
that it is fastened tightly in place. If the water pipes are new or have not been used for
an extended period of time, let the water run to make sure that the water is clear. This
precaution is needed to avoid the risk of the water inlet to be blocked and damaging
the appliance.
Drain Hose Connection
Insert the drain hose into a drain pipe with a minimum diameter
of 4 cm, or let it run into the sink, making sure to avoid bending
or crimping. Use the special plastic support that comes with the
appliance. The free end of the hose must be at a height between
40 and 100cm and must not be immersed in water.
4. Installation
Inlet pipe connector Drain pipe connector
SINK
DISHWASHER
Min 100mm
WARNING
• Improper connection of the equipment earthing conductor can result in the risk of an electric
shock.
• Check with a qualied electrician or service representative if you are in doubt whether the
appliance is properly earthed.
• Do not modify the plug provided with the appliance. If the plug does not t properly to the
outlet, please have a qualied electrician install a proper outlet.
WARNING
Turn off tab after use.
To Next Page
Loading...