Page 9
4. Installation
How to Drain Excess Water From Hoses
If the sink is 1000mm higher from the oor, the excess water in the hoses cannot be drained directly into the
sink. It will be necessary to drain excess water from hoses into a bowl or suitable container that is held outside
and lower than the sink.
Water Outlet
Connect the water drain hose. The drain hose must be correctly tted to avoid water leaks.
Ensure that the water inlet hose is not kinked or squashed.
Extension Hose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.
Syphon Connection
The waste connection must be at a height of between 40cm (minimum) and 100cm (maximum) from the
bottom of the dishwasher. The water drain hose should be xed by a hose clip.
Before First Use
The following things should be checked before starting the dishwasher.
• The dishwasher is level and xed properly
• The inlet valve is open
• No leakage at the connections of drainage hose and cold water supply.
• 10amp plug is correctly connected.
• The power is switched on
• The inlet and drain hoses are not kinked or knotted.
• All packing materials and protective lm should be taken out from the dishwasher
To Next Page