Why does my Scandomestic Washer not work / start?
If your Scandomestic Washer isn't starting, make sure it's properly plugged into a working power socket and that the power is on. Check the wall socket by testing it with another appliance. Ensure the door is correctly closed, and that you've selected the desired program and pressed the start button. Also, verify that the washing machine isn't in pause or time delay mode.
What to do if my Scandomestic Washer shows E2 error?
To address error code E2 or 2 LED flashes on your Scandomestic Washer, verify that the water supply tap is fully open and the supply hose isn't bent or trapped. Ensure the drain pipe is at the correct height as specified in the installation section. Close the tap, detach the filler hose, and clean the anti-sand filter. Also, check the filter for clogs or foreign objects that may be obstructing water flow.
Why is my Scandomestic Washer making strong vibrations / noises during the spin cycle?
To resolve strong vibrations or noises during the spin cycle of your Scandomestic Washer, ensure the appliance is fully leveled by adjusting the feet. Verify that all transport screws, rubber bungs, and spacer tubes have been removed. Also, check the drum for any foreign objects like coins or buttons.
Why is my Scandomestic Washer not spinning?
If your Scandomestic Washer is not spinning, try removing the load, detangling it, and reloading it before restarting the spin program. If water hasn't completely drained, wait a few minutes. Check if the "no spin" function is selected. Ensure you are using the correct amount of detergent, as excessive detergent can impede the spin cycle. Review the selected options and their impact on the spin cycle.
What to do if my Scandomestic Washer shows E3 error?
To address error code E3 or 3 LED flashes on your Scandomestic Washer, check the filter for clogs or foreign objects. Make sure the drain hose isn’t bent or trapped. Ensure your home drainage system isn't blocked by trying to drain water in the sink.
Why is water leaking from my Scandomestic Washer?
If you find water leaked on the floor near your Scandomestic Washer, it may be due to a leak from the seal between the tap, supply hose, and fill valve; replace the seal and tighten the hose connections correctly. Also, make sure the front filter is correctly closed.
What to do if my Scandomestic Washer shows E7 error?
To address error code E7 or 7 LED flashes on your Scandomestic Washer, make sure the door is correctly closed and that no clothes are preventing it from closing fully. If the door is locked, turn off and unplug the washing machine, wait 2-3 minutes, and then reopen the door.
What to do if my Scandomestic Washer shows E4 error?
To address error code E4 or 4 LED flashes on your Scandomestic Washer, ensure you are using the correct amount of detergent and that the detergent is designed for use in a washing machine.
General| Brand | Scandomestic |
|---|---|
| Model | STL 712 W |
| Category | Washer |
| Language | English |
To Next Page
