PA680
User Manual
AM/FM RADIO WITH SPEAKER
1 Power indicator
2 Volume control
（
with ON/OFF switch)
3 Tuning switch
（
AM/FM
）
4 Tuning knop
5 AUX INPUT (3.5mm jack)
6 Speaker
7 DC jack
8 FM antenna
9 Battery compartment door
1) BATTERY INSTALLATION
Remove the battery compartment door (9); insert four AA batteries into the battery compartment.
Be sure to follow the correct battery polarity a as marked inside the compartment.
Then close the battery compartment door.
2) RADIO OPERATION
Switch on the radio by turning volume control (2), the power indicator will be on.
Push the Am/FM tuning switch to AM or FM position, then tune into a desired station
using the tuning knob (4)
Extend the telescopic antenna (8) for maximum FM reception.
3) AUX/MP3 INPUT
Connect the MP3 or other audio devices to the 3.5mm jack (5)
Switch ON using the volume control (2).
4) SPECIFICATIONS
Working voltage Batteries: “AA”1.5V×4PCS (DC6V 900mA)
Speaker Ø50mm 4 ohm 3W*1
Radio frequency AM 540-1600KHz
FM 88
～
108MHz
To Next Page
Need help?
General
