E&OE
SCARAB MISTRAL - Abbreviated Operating Instructions
SWEEP MODE
VEHICLE ENGINE RUNNING. AIR TANKS FULL.
1. Vehicle stopped and in Neutral gear. Hand brake ON. (L1)OFF.
2. Auxiliary Engine switch ON (Main Panel). Engine speed will change to 1100rpm.
If reduction gearbox fitted, Step 3. If not, Step 4.
3. Clutch de-pressed, F1 switch ON. symbol will change to the symbol on the LCD screen.
If the symbol flashes and a buzzer sounds, press the F1 switch. Drive the vehicle slightly
forward and repeat step 3.
4. Select required sweeping equipment (Main Panel). Fan ON. (L1) ON.
5. Engage a suitable gear. Hand brake OFF. Clutch released, commence sweeping.
All sweeping gear is stopped and raised automatically when REVERSE is selected. Reduction
gearbox will disengage. Sweeping equipment and reduction gearbox will re-engage, when
forward is selected.
LEAVING SWEEP MODE / DISENGAGING REDUCTION DRIVE
1. Vehicle stopped and in Neutral gear. Hand brake ON.
2. (L1) OFF. Fan OFF (Main Panel).
If reduction gearbox fitted, Step 3. If it has not, Step 4.
3. Clutch de-pressed, F1 switch OFF. symbol will change to the symbol on the LCD
screen. Clutch released.
If the symbol flashes and a buzzer sounds, press the F1 switch. Drive the vehicle slightly
forward and repeat step 3.
4. Auxiliary Engine switch OFF (Main Panel).
Before stopping the auxiliary engine, allow it to idle for at least 2 minutes to allow the turbo-
charger to cool down.
This document is designed as a quick reference guide, to allow the operator to drive the
vehicle in Normal or Reduction Gearbox Mode and operate the basic controls. It does not
constitute the full operating instructions.
EQUIPMENT NOT SELECTED
EQUIPMENT PRE-SELECTED
EQUIPMENT OPERATING
WATER PRE-SELECTED
EQUIPMENT + WATER PRE-SELECTED
MAIN EQUIPMENT COLOUR CODES
WIDE SWEEP WATER ACTIVE
NOZZLE TILT INDICTOR
WORK LIGHT ON
BRUSH ACTIVE
WATER ACTIVE
PRESS TO DISABLE
HOPPER RAISE/LOWER AND REAR
DOOR OPEN/CLOSE WARNING BUZZER
OPTIONS*
OPTIONS*
BRUSH SPEED
LEFT
SIDE BRUSH
LEFT SUCTION
WIDESWEEP BRUSH
RIGHT SUCTION
RIGHT
SIDE BRUSH
LEFT
WORKLIGHT
LEFT WATER
WIDESWEEP
WATER
RIGHT WATER
RIGHT
WORKLIGHT
ENGINE SPEED
ENGINE SPEED
LEFT ADDITIONAL
RIGHT ADDITIONAL
CRAWLER
DRIVE
MAIN DRIVE
SUCTION FAN
ON
SUCTION FAN
BOOST
HOPPER NOT
DOWN
H-P WATER
PUMP
WATER TANK
LOW
H-P PUMP
NO WATER
HYDRAULIC OIL
LOW
HYDRAULIC OIL
TEMP
SERVICE
REMINDER
ACTIVE FAULT
PRESENT
MAJOR ON-SCREEN INFORMATION
AND WARNING SYMBOLS
HIGH-PRESSURE
NOT APPLICABLE
AUXILIARY PANEL
NOZZLE TILT
SUCTION FAN
SUCTION FAN BOOST
FAVOURITE
SETTING
WATER*
WATER*
PUMP*
L1
*OPTIONS
MULTI-FUNCTION LEVER
ON RIGHT HAND DRIVE VEHICLES
Lever Right, side brush(es) OUT.
Lever Left, side brush(es) IN.
On machines fitted with variable extend and
retraction, move the lever momentarily in
the desired direction to ‘nudge’ the
brush(es).
Reversed on Left Hand Drive.
NOZZLE-TILT FUNCTION
Pull lever back and hold to OPEN. Release to
CLOSE.
Variable Tilt:-Pull lever back to ‘nudge’
DOWN from the LOCKED OPEN position.
Press and hold down the Safety Interlock and the
appropriate control switch.
For safety reasons only operate the Remote
Control controls from outside the vehicle,
from a vantage point that affords a good view
of the sweeper and its surroundings.
Before closing the rear door, ensure adequate
clearance and seal cleanliness.
AUXILIARY ENGINE
START/STOP + SWEEP MODE
OFF
ON
TILT
SIDE SIDE
BRUSH BRUSH
NOZZLE
= RAISE HOPPER
= LOWER HOPPER
= OPEN DOOR
= CLOSE DOOR
= SAFETY INTERLOCK
= OPTION
REMOTE CONTROL
PLEASE REFER TO REVERSE FOR HEALTH & SAFETY ADVICE
To Next Page
Need help?
General
