5. Once the scanning finishes, you can begin to watch HDTV.
If You have connected cable or satellite Set top-Boxes to the HDTV
1. Press the button on the side of the HD Display or the SOURCE button on the remote control and you will see
the picture above.
2. Use buttons to select the source you want to switch to and press the ENTER button in the middle of
the buttons.
3. If you have connected coax cable (the cable with a needle in the middle and a ring to tighten the
connection) from the box to the TV, you’ll need to change to the correct channel. Make sure your source is
TV and press 3 to ENTER on the TV’s remote. If that does not work you’ll need to connect your Satellite or
Cable Company for support.
Please Note:
Not all broadcasts are in High Definition (HD). Please refer to your local broadcasting stations for more
information.
The HD Display’s tuner is designed for HD Display therefore requires a stronger signal than normal Displays. If
you cannot achieve that signal level with your antenna or cable, your HD Display might lose picture or sound.
HDMI 1 doubles as a MHL enabled port, so if you have a cell phone that supports the Mobile High-definition
Link, you can purchase a MHL cable and connect it to HDMI 1.
SCEPTRE Remote Control
Please insert two AAA batteries into the remote control. Make sure that you match the (+) and (-) symbols on the
batteries with the (+) and (-) symbols inside the battery compartment. Afterwards, re-attach the battery cover.
To Next Page
Loading...
Need help?
General
