Operating manual f o r caravan-charging system CSV 410
4
Date: 20.02.2020 8050102 BA / EN
The CSV 410 caravan charging system is the central power supply unit for
all 12 V consumers connected to the caravan’s electrical system. It is usually
located in a cupboard or storage area and is accessible from the front in or-
der to change fuses.
The caravan charging system has been designed solely for connecting to a
12 V onboard supply.
Connected units can be supplied from the caravan battery or the towing ve-
hicle’s battery if a mains supply is not available.
Because the device provides a hum-free, stabilised output voltage, sensitive
consumers such as transistor lights and radios can be connected and powe-
red.
The CSV 410 caravan charging system consists of:
F a charge module for charging all connected batteries
F the complete 12V distribution system
F fuses for the 12V circuits
F a battery booster
An ST ... switch panel must be installed as a minimum to run the system.
Connections are provided for:
F Solar charge regulator
F Control and display panel
Flat vehicle fuses protect the various circuits.
F Excess temperature
F Overload
F Short circuit
230V AC 10%, 47 -- 63 Hz sinusoidal, protection class I
12V outputs may only be loaded up to a maximum of 90% of the rated cur-
rent of the associated fuse (see block diagram or nameplate).
Modules
Required
control circuits
Protective circuits
Mains connection
Current-carrying
capacity
To Next Page
Loading...
