Instruction Manual for Electroblock EBL 252
9
Date: 23.01.2020
8110253 BA / EN
7 Technical details
Dimensions 130 x 275 x 170 (H x W x D in mm), inclu-
ding attachment feet
Weight Approx. 2 kg
Casing PA (polyamide)
Colour Gentian blue RAL 5010
Front Aluminium, powder coated, light grey (RAL
7035)
Mains connection 230V
~, 10%, 47 to 63 Hz sinusoidal
Max. power consumption 230V
~ 1.9 A
Output voltage 12V DC
Max. overall output current, 12V DC 18 A
Storage temperature -- 20 C ... 70 C
Operating temperature -- 20 C ... 45 C
Protection class I
Protection rating IP20
Battery types AGM
Lead-acid
Battery rating 55 Ah or greater
Standby current from leisure battery With DT ... / LT ... control and display panel
: approx. 4 mA (depending on operator and
control panel used) under the following
conditions
F No mains connection
F Leisure battery voltage 12.6V
F 12V main switch ”OFF”
Charging for mains connection
F Leisure battery
Charging curve
Final charge voltage
Charging current
Voltage for conservation charging
IUoU
Lead-acid: 14,3 V / AGM: 14,7
18 A in the entire mains voltage range, elec-
tronically limited, minus the charging current
into the vehicle battery
13.7V with automatic switchover
F Starter battery
charge current, conservation charging Max. 2.6 A
Alternator D+ loading by EBL Approx. 1 mA
D+ output loading on EBL Max. 2 A
Solar regulator connector MNL 3-pin for batt. 1 and batt. 2; e.g.
Schaudt LR 1218
Solar regulator charge current Max. 20 A
Auxiliary charger connector MNL 2-pin, e.g. Schaudt LAS 1218
Charge current of aux. charger Max. 20 A
Renewed charging cycle For battery voltage below 13.7V
Switchover to main charge With approx. 5 seconds delay
To Next Page
Loading...
