EasyManua.ls Logo

Scheer MH 10 Micro - General Operating Instructions

Default Icon
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
www.scheer-heizsysteme.de
MH-SERIES
warning and safety signs
•
Surrounding temperatures higher than 110°C (230°F) can cause damage to the electronics.
• Never use or store the heater in areas of 110°C (230°F) or more.
NOTICE
Risk of malfunction or damage by heat exposure!
•
If the water freezes in the heat circuit or fresh water supply system, it can cause damage to the
equipment.
• Make sure to have at least 20% of antifreeze mixed into the heating circuit water.
• In risk of frost, drain the fresh water out of a heat system with plate heat exchanger.
NOTICE
Risk of malfunction or damage by frost!
general operating instructions
Note: SCHEER cannot be held liable for:
• Defects and damage, which are due to installation or repair by unauthorized and untrained persons.
• Failure to comply with the instructions and the warning/safety signs.
• The installation of non-original spare parts.
Please note the following general operating instructions after installing and during the use of the
MH-heating system:
• The heating system must be turned o before you get fuel at gas stations.
• The year of the rst start-up must be permanently marked on the identication plate.
• Make sure all existing shut-o valves of the fuel return line are open before using the system.
• Check the openings of the combustion air supply and exhaust pipe for dirt and clean if necessary.
• After replacing the vehicles cooling uid make sure to bleed the system of air thoroughly. Add cooling
uid when needed.
• After replacing the heating circuit water (solution) make sure to bleed the system of air thoroughly.
Add solution when needed. (at least 20% antifreeze)
• Make sure to use the fuel and operation power indicated on the identication plate.
• In case of heavy smoke development, unusual burner noise, or smell of fuel, disable the heating
system by removing its fuse. Operate the system only, after a technical inspection by a SHEER trained
person.
• Turn on the heating system at least once a month for 10 min.
• The heating system must be checked by a SCHEER trained person, before each heating season.
• Liability claims can only be asserted, if the claimant can prove adherence to the installation,
maintenance, and safety instructions.
5

Other manuals for Scheer MH 10 Micro

Related product manuals