www.scheppach.com
GB
|
37
- For additional take-back conditions of the man-
ufacturers and distributors, please contact the
respective customer service.
• In the case of delivery of a new electrical device by
the manufacturer to a private household, the latter
may arrange for the free collection of the old elec-
trical device upon request from the end-user. Get in
contact with the manufacturer’s customer service.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. Dierent provisions may apply to the
disposal of electrical and electronic appliances in
countries outside the European Union.
• Owners or users of electrical and electronic devices
are legally obliged to return them after use.
• The end user is responsible for deleting their per-
sonal data from the old device being disposed of!
• The symbol of the crossed-out dustbin means that
waste electrical and electronic equipment must not
be disposed of with household waste.
• Waste electrical and electronic equipment can be
handed in free of charge at the following places:
- Public disposal or collection points (e.g. municipal
works yards).
- Points of sale of electrical appliances (stationary
and online), provided that dealers are obliged to
take them back or oer to do so voluntarily.
- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.
17. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your product failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault Possible cause Remedy
The sprayer
does not start.
The sprayer is not plugged in. Plug in the sprayer.
The socket is not outputting
power.
Check the precise mains voltage.
The extension cable is damaged
or its capacity is too low.
Exchange the extension cable or replace it with a cable of a
suitable voltage.
The sprayer has switched o
under pressure.
The motor switches on and o during spraying to regulate
the pressure. This is a normal process.
No (or very
little) spraying
material is
sprayed.
The variable nozzle is clogged.
Clean the variable nozzle with the help of a cleaning
needle.
The suction hose is clogged. Clean the suction hose.
The pressure control is set too
low.
Set the pressure control higher by turning the dial
clockwise.
The suction hose is not tight
enough.
Readjust the suction hose on the suction hose inlet
connection and x the screw on the metal hose clamp
for the suction hose inlet connection with a at-blade
screwdriver.
The suction hose mesh lter is
clogged.
Clean or replace it. Only use cleaning solution suitable for
the material.
To Next Page
Loading...
