26 GB
Troubleshooting
Failure Possible cause Solution
Motor does not start a) Fastening nut tightened insufficiently
b) Extension cable defect
c) Connections on the motor or switch
defect
d) Motor or switch defect
a) Check the mains fuse
b) See “Electrical Connection” in the
operating
c) Have it checked by an electrician Brake
does not bleed
d) See “Electrical Connection” in the oper-
ating manual
Motor runs forward or
backwards
Capacitor defect Have it exchanged by an electrician
No motor output turns
off automatically
a) Overload by dull saw
b) Wrong saw blade
a) Insert a sharpened saw blade; motor can
be turned on agai
b) Select saw band according to instructions
Burns on the cutting
surface
a) Fastening nut tightened insufficiently
b) Wrong saw blade
a) Insert a sharpened saw blade
b)Select saw band according to instructions
Saw band clamps when
working
a) Saw band blunt
a) saw band
c) Leadership poorly adjusted
a) Replace saw band
b) Clean saw band
c) Saw band guidance according to instruc-
tions
To Next Page
Need help?
General