Why does my Scheppach HBS20 motor start up slowly?
If your Scheppach Saw motor starts up slowly and does not reach operating speed, the voltage may be too low, the coils may be damaged, or the capacitor may be burnt. Contact the utility provider to check the voltage and arrange for inspection of the motor or replacement of the capacitor by a specialist.
Why does my Scheppach HBS20 motor overheat easily?
The Scheppach Saw motor may overheat due to overloading or insufficient cooling. To resolve this, avoid overloading the motor while cutting and remove any dust from the motor to ensure optimal cooling.
What to do if Scheppach HBS20 Saw cut is rough or wavy?
If the saw cut is rough or wavy, it might be due to a dull saw blade or a tooth shape that isn't appropriate for the material thickness. Resharpen the saw blade or use a more suitable saw blade to fix this.
What to do if Scheppach HBS20 Saw blade jams during cutting work?
If the saw blade jams during cutting work, it could be due to several reasons: * A blunt saw blade. * Deposits on the saw blade. * Poorly set guide. Change or clean the saw blade, and ensure the saw blade guide is set correctly according to the operating instructions.
What to do if Scheppach Saw workpiece pulls away and/or splinters?
If the workpiece pulls away or splinters while using the Scheppach Saw, it's likely due to excessive cutting pressure or using an unsuitable saw blade. Try reducing the cutting pressure and insert a more suitable saw blade.
What to do if workpiece pulls away and/or splinters when using Scheppach HBS20?
If the workpiece pulls away or splinters when using your Scheppach Saw, it may be due to excessive cutting pressure or an unsuitable saw blade. Insert a suitable saw blade.
Why does my Scheppach HBS20 Saw motor not reach its full power?
If your Scheppach Saw motor does not reach its full power, the circuits in the network may be overloaded by other equipment like lamps or other motors. Avoid using other equipment or motors on the same circuit.
What causes burn marks on the wood when cutting with my Scheppach Saw?
Burn marks appearing on the wood during cutting with your Scheppach Saw can be caused by a blunt or wrong saw blade. Change the saw blade or select a saw blade according to the operating instructions.
What to do if my Scheppach HBS20 Saw motor does not start?
If your Scheppach Saw motor isn't starting, there are a few potential causes. First, check the mains fuse. It's also possible there's a defect in the extension cable; in this case, consult the “Electrical Connection” section in the operating manual. Finally, the connections on the motor or switch could be defective, which would require an electrician to check.
Why Scheppach HBS20 motor does not reach its full power?
If the Scheppach Saw motor isn't reaching its full power, it might be because the circuits in the network are overloaded by other equipment or motors. Avoid using other equipment or motors on the same circuit to resolve this.
General| Cutting Height | 80 mm |
|---|---|
| Weight | 17 kg |
| Saw blade length | 1400 mm |
| Saw band speed | 880 m/min |
| Table size | 300 x 300 mm |
| Wheel diameter | 200 mm |
| Motor | Induction motor |
| Max Cutting Depth at 90° | 80 mm |
| Table tilt | 0° to 45° |
| Input | 230 V |
To Next Page
