Why does my Scheppach Saw motor not work?
The Scheppach Saw motor might not be working due to several reasons: the motor, cable, or plug could be defective; the fuses might be burnt; or the housing cover might be open, activating a limit switch. To address this, have a specialist inspect the machine, replace fuses if necessary, and ensure the housing cover is closed correctly.
What to do if my Scheppach HBS20 Saw motor turns off automatically?
If the motor of your Scheppach Saw turns off automatically, it may be due to overload caused by a dull saw blade, which triggers the thermoprotection. To resolve this, insert a sharpened saw blade. The motor can be turned on again after a cooling period.
How to fix a Scheppach HBS20 Saw blade that gets loose?
If the saw blade on your Scheppach Saw gets loose after turning off the motor, it's likely because the fastening nut wasn't tightened enough. Make sure to tighten the fastening nut, using the M20 lefthanded thread.
Why Scheppach Saw motor starts up slowly and does not reach operating speed?
If the Scheppach Saw motor starts up slowly and doesn't reach operating speed, it could be due to low voltage, damaged coils, or a burnt capacitor. Contact the utility provider to check the voltage. It is recommended arranging for inspection of the motor by a specialist. Also, arrange for a specialist to replace the capacitor if needed.
Why Scheppach HBS20 motor does not reach its full power?
If the Scheppach Saw motor isn't reaching its full power, it might be because the circuits in the network are overloaded by other equipment or motors. Avoid using other equipment or motors on the same circuit to resolve this.
Why Scheppach HBS20 Saw motor makes excessive noise?
If the Scheppach Saw motor is making excessive noise, it could be due to damaged coils or a defective motor. It is recommended to arrange for inspection of the motor by a specialist.
Why Scheppach Saw motor does not work?
If the motor does not work, the motor, cable, or plug might be defective, or the housing cover might be open, activating a limit switch. Check the fuses and replace them if necessary, and ensure the housing cover is closed correctly. It is recommended arranging for inspection of the machine by a specialist. Never repair the motor yourself due to the danger involved.
How to fix Scheppach HBS20 blade that is not running straight?
If the saw blade isn't running straight, it could be because the guide has been wrongly set or you're using the wrong saw blade. Set the saw blade guide according to the operating instructions and select an appropriate saw blade.
What to do if burn marks appear on the wood during the cutting work with Scheppach HBS20 Saw?
If burn marks appear on the wood during cutting, it could be due to a blunt or incorrect saw blade. Try changing to a sharp and appropriate saw blade for the material you're cutting.
What to do if Scheppach Saw workpiece pulls away and/or splinters?
If the workpiece pulls away or splinters while using the Scheppach Saw, it's likely due to excessive cutting pressure or using an unsuitable saw blade. Try reducing the cutting pressure and insert a more suitable saw blade.
General| Cutting Height | 80 mm |
|---|---|
| Weight | 17 kg |
| Saw blade length | 1400 mm |
| Saw band speed | 880 m/min |
| Table size | 300 x 300 mm |
| Wheel diameter | 200 mm |
| Motor | Induction motor |
| Max Cutting Depth at 90° | 80 mm |
| Table tilt | 0° to 45° |
| Input | 230 V |
To Next Page
