189
Remedierea avariilor
Defecţiune Cauza posibilă Remediere
Saw blade gets loose after
turning off the motor
Fastening
nut tightened
insufciently
Tighten fastening nut, M20 lefthanded thread
Motor does not start a) Fastening
nut tightened
insufciently
a) Check the mains fuse.
b) Extension cable
defect
b) See „Electrical Connection“ in the operating manual
c) Connections on
the motor or switch
defect
c) Have it checked by an electrician
No motor output turns off
automatically
Overload by
dull saw blade,
thermoprotection is
triggered
Insert a sharpened saw blade; motor can be turned on again
after the cooling period
Burns on the cutting surface c) with longitudinal
cuts
c) Exchange the longitudinal stop
d) with cross cuts d) Align the slide carriage with the saw blade
a) Fastening
nut tightened
insufciently
a) Tighten fastening nut, M20 lefthanded thread
b) Wrong saw blade b) Insert saw blade with 20 or 28 teeth for longitudinal cuts
To Next Page
Loading...
Need help?
General
