How to change turning direction on Scheppach BASA3 Saw?
If the motor has an incorrect turning direction, it is likely due to an incorrect connection. Change the direction of rotation on the CEE connector.
Why does my Scheppach BASA3 Saw motor not start?
If the Scheppach Saw motor doesn't start, check the mains fuse. Unplug the mains fuse, check it, and replace it if necessary. Ensure the housing cover is closed precisely. If problems persist, have the saw checked by an electrician or arrange for inspection of the machine by a specialist. Never repair the motor yourself.
Why Scheppach Saw band jams when working?
The saw band might be jamming due to several reasons. The saw band could be blunt or resinous, so replace or clean it. Also, the guide might be incorrectly adjusted; in this case, adjust the saw band guide correctly.
What to do if my Scheppach Saw motor overheats easily?
If the Scheppach Saw motor overheats easily, it may be due to overloading or insufficient cooling. Avoid overloading the motor while cutting. Remove dust from the motor to ensure optimal cooling.
Why Scheppach Saw band drifting?
If the saw band is drifting, it could be because the guide is incorrectly adjusted. Adjust the saw band guide correctly. Also, make sure you select the correct saw band.
Why Scheppach BASA3 cut is rough or wavy?
If the saw cut is rough or wavy, the saw band might be dull, or the tooth shape might not be appropriate for the material thickness. Resharpen the saw band or insert a suitable saw band.
What to do if my Scheppach BASA3 Saw band doesn’t move?
If the saw band doesn’t move, check the mains fuse. Have the saw checked by an electrician or arrange for inspection of the machine by a specialist. Never repair the motor yourself. Check fuses and replace as necessary.
Why Scheppach BASA3 workpiece pulls away and/or splinters?
If the workpiece pulls away or splinters, it could be due to excessive cutting pressure or an unsuitable saw band. Insert a suitable saw band.
Why there are burn marks on the wood when working with Scheppach Saw?
Burn marks on the wood when working indicate that the saw band is blunt. Replace the saw band. Also, ensure you select the correct saw band.
Why Scheppach Saw motor makes excessive noise?
If the motor makes excessive noise, it could be due to damaged coils or a defective motor. Arrange for inspection of the motor by a specialist.
General| Type | Bandsaw |
|---|---|
| Table Size | 300 x 300 mm |
| Motor | 230 V |
| Blade Width | 6 mm |
| Cutting Speed | 800 m/min |
| Table Tilt | 0° to 45° |
To Next Page
