Scheppach basato 3 User Manual

12
Special Accessories
Cross cutting jig 7312 0025
Circular cutting device
Bit stop
}
7319 0710
Grinding belt device
Underframe for tables 7319 0709
Automatic starter, type ALV 2 7910 4010
Type ALV 10 7910 4020
Saw bands
for wood:
12/0.5/2360 mm, 4 teeth/inch 7319 0701
Standard saw band
15/0.5/2360 mm, 4 teeth/inch 7319 0704
Straight upright cuts with longitudinal stop
for wood and synthetic materials:
6/0.5/2360 mm, 6 teeth/inch 7319 0702
Turning works with small radius 25 mm
12/0.5/2360 mm, 6 teeth/inch 7319 0705
Precision cutting works
Different materials:
wood, synthetic materials, metals
3.5/0.5/2360 mm, 14 teeth/inch 7319 0706
Extra-fine cutting works, extremely small radiuses
Non-ferrous metals up to 10 mm
6/0.65/2360 mm, 22 teeth/inch 73190707
straight cuts and turning works
Synthetic materials, non-ferrous metals
6/0.65/2360 mm, 10 teeth/inch 73190703
Synthetic materials, non-ferrous metals above 15 mm
12/0.65/2360 mm, 10 teeth/inch 73190708
straight cuts and large radiuses > 60 mm
Troubleshooting
Failure Possible cause Solution
Saw blade gets loose after a) Fastening nut tightened a) Tighten fastening nut, M20 left-handed thread
turning off the motor insufficiently
Motor does not start a) Fastening nut tightened insufficiently a) Check the mains fuse.
b) Extension cable defect b) See “Electrical Connection” in the operating
manual, pages GB 11
c) Connections on the motor or c) Have it checked by an electrician
switch defect Brake does not bleed
d) Motor or switch defect d) See “Electrical Connection” in the operating
manual, pages GB 11
Motor runs forward or Capacitor defect Have it exchanged by an electrician
backwards
No motor output Overload by dull saw Insert a sharpened saw blade; motor can be
turned on again
turns off automatically blade, thermoprotection is triggered after the cooling period
Burns on the cutting a) Fastening nut tightened insufficiently a) Insert a sharpened saw blade
surface b) Wrong saw blade b) Insert saw blade with 20 or 28 teeth for
longitudinal cuts
c) with longitudinal cuts c) Longitudinal stop not parallel c) Exchange the longitudinal stop
d) with cross cuts d) Slide carriage not parallel Align the slide carriage with the saw blade

Scheppach basato 3 Specifications

General

Brand	Scheppach
Model	basato 3
Category	Saw
Language	English