Scheppach DP3000 User Manual

16
Stopping engine
m Attention!
To stop the engine in case of emergency, simply turn
the engine switch (2) to the “OFF“ position.
Under normal conditions, use the following proce-
dure.
• Move the throttle lever (1) to the “L“ position.
• Let the engine idle for one or two minutes.
• Turn the engine switch (2) to the “OFF” position.
• Turn the fuel valve lever (15) contrary to the po-
sition.
m NOTE
Do not move the choke control (16) to stop engine.
Backre or engine damage may occur.
10. Cleaning
Caution!
Switch o󰀨 the engine and pull the spark plug boot
from the spark plug before doing any cleaning and
maintenance work on the machine.
Keep all safety machines, air vents and the engine
housing free of dirt and dust. Wipe the machine with
a clean cloth or clean it with compressed air at low
pressure.
We recommend that you clean your machine after
each use.
Clean the unit regularly with a damp cloth and some
soft soap. Do not use cleaning agents or solvents;
they may damage the plastic parts of the machine.
Make sure that no water can get inside the unit.
11. Transport
m WARNING
Let the engine cool down before transporting the ma-
chine or storing indoors to avoid burns or re haz-
ards. If you want to transport the machine empty
the fuel tank before. Clean the unit with a brush or a
broom of coarse dirt.
Operating
• After the engine warms up, pull the throttle lever
(1) to accelerate the engine speed (shown Fig.1
pos.H).
• Engage the required gear (7) and slowly squeeze
the clutch control lever (4). Press the latch (Fig. 8
Pos.A) to operate with the clutch lever (4). If the
gear does not engage straight away, slowly release
the clutch lever (4) and try it again.
Steering
The dumper has the steering levers (3)+(5) on the
handlebars and this makes steering very easy. To
turn right or left, simply operate the corresponding
right (3) or left (5) steering lever.
The sensitivity of the steering increases in proportion
to the speed of the machine and that with the empty
machine, a light pressure on the lever is all that is
needed to turn. While when the machine is loaded,
more pressure is required.
m Attention!
The dumper has a maximum load capacity of
300kg. However, it is advisable to assess the load
and adjust it according to the ground on which the
machine will be used.
It is therefore advisable to cover such stretches us-
ing low gear and taking extra care. Avoid sharp turns
and frequent changes of the direction while driving
on the road, in particularly on rough, hard terrains full
of sharp, uneven points with a high degree of friction.
Remember that the unit has all-wheel drive but
you need to be careful when working under ad-
verse weather conditions (ice, heavy rain and
snow) or at soil types that can lead to instability
of the dumper.
Please note that this is a wheeled vehicle that
considerable pitching when driving over bumps,
holes and steps subject.
When the clutch control lever (4) is released, the
machine will stop and brake automatically.
If you stop the machine on a steep slope, you
should position a wedge in the direction of fall
to secure the machine.
Idle speed
Set the throttle control lever (1) to its “L” position to
reduce stress on the engine when working is not
being performed.
Lowering the engine speed to idle the engine will
help extend the life of the engine, as well as con-
serve fuel and reduce the noise level of the machine.

Scheppach DP3000 Specifications

General

Fuel type	Gasoline
Motor power	6.5 hp
Product type	Motorized wheelbarrow
Maximum power	- W
Number of wheels	4 wheel(s)
Fuel tank capacity	3.6 L
Engine displacement	196 cm³
Maximum load weight	300 kg
Engine number of strokes	-

Weight and Dimensions

Depth	1380 mm
Width	700 mm
Height	1000 mm
Weight	147400 g