www.scheppach.com
30
|
GB
- Damaged switches must be replaced at a cus-
tomer service workshop.
-
cables.
-
21. ATTENTION!
- The use of other insertion tools and other acces-
22.
electrician
- This electric tool conforms to the applicable
-
parts. Otherwise accidents can occur.
Additional safety instructions
•
maintenance work on the blade!
•
a device to stop the workpiece from twisting.
• When cutting boards in upright position, use a de-
vice to prevent kick-back.
•
with woodworking dust emission values and to en-
sure reliable operation.
•
work on the machine.
•
• -
power failure.
•
that the voltage marked on the rating plate is the
•
• Persons working on the machine should not be dis-
tracted.
• Note the direction of rotation of the motor and blade.
•
them out of operation.
• Never cut workpieces which are too small to hold
• -
es of wood when the saw blade is running.
• It is imperative to observe the accident prevention
- Check the connection cable of the electric tool
specialist when damaged.
-
them when damaged.
-
grease.
15. Pull the plug out of the outlet
-
wood pieces from the running saw blade.
- During non-use of the electric tool or prior to
maintenance and when replacing tools such as
saw blades, bits, milling heads.
- When the saw blade is blocked due to abnormal
the work piece and ensure that the saw blade
runs free. Turn the machine on and start new
cutting operation with reduced feed force.
16.
-
17. Avoid inadvertent starting
-
plugging the plug into an outlet.
18. Use extension cables for outdoors
-
extension cables for use outdoors.
-
19. Remain attentive
-
sensible when working. Do not use the electric
20. Check the electric tool for potential damage
- Protective devices and other parts must be care-
and function as intended prior to continued use
of the electric tool.
- Check whether the moving parts function fault-
-
aged.
-
-
ation of the electric tool.
-
the open position.
- Damaged protective devices and parts must be
-
To Next Page
Loading...
Need help?
General
Weight and Dimensions
