www.scheppach.com
GB
|
31
Remaining hazards
-
•
saw band due to improper handling of the work
due to improper handling, such as working without
the push stick.
•
wood chips. Wear personal protective cloth such as
•
check saw band for such defects.
•
saw band. Wear proper gloves.
• -
ing on the machine.
• The use of incorrect or damaged mains cables can
•
•
-
be present.
• -
„Proper Use“ and in the entire operating manual.
•
associations.
•
close as possible to the work piece.
mIMPORTANT! Support long work pieces (e.g. with a
roller table) to prevent them sagging at the end of a cut.
• Make sure the blade guard (4) is in its lower position
when the saw is being transported.
•
the machine.
•
must not be used.
• If the table insert is worn, replace it.
• Never operate the machine if either the door pro-
open.
• Ensure that the choice of blade and the selected
speed are suitable for the material to be cut.
• Do not begin cleaning the blade until it has come to
a complete standstill.
• For straight cuts of small work pieces against the
longitudinal limit stop the push stick has to be used.
• Wear gloves when handling the saw blade and
rough materials
• The band saw blade guard should be in its lowest
position close to the bench during transport.
• For miter cuts when the table is tilted, the parallel
stop must be positioned on the lower part of the ta-
ble.
• Never use guards to lift or transport items.
• Ensure that the band saw blade guards are used and
•
band saw blade. Use a push stick for narrow cuts.
• The push stick has to be stored on the intended de-
vice, so that it can be reached from normal working
• In the normal operating position the operator is in
front of the machine.
mWARNING! This electric tool generates an electro-
active or passive medical implants under certain con-
-
-
er of the medical implant prior to operating the electric
tool.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
