Do not try to remove a part from the machine while it •
is pressurized.
Make sure the lubrication oil is clean and always avail-•
able in sufficient quantity. Change the oil according to
the instructions given in the chapter „Maintenance“
of this manual.
Wear safety gears including goggles or a screen, ear pro-•
tection, breathing mask and protective clothing.
After connection to the mains and switching on, the •
machine starts automatically.
Air escaping from the compressor may not be inhaled.•
Check the pressure control valve daily before starting •
work.
Drain humidity from the tank. Avoid tank corrosion.•
Cut off the mains supply, remove the power supply •
plug, and relieve the pressure before starting mainte-
nance work.
Wear goggles.
Wear ear protection.
Wear a breathing mask.
Never direct the output air from the compressor towards
a part of the body or a person. Never try to block the air
escape with your finger or a part of your body.
m Use as authorized
The machine meets all valid EC machine guidelines.
The machine must only be used in technically perfect •
condition and conscious of the risks, in accordance
with its designated use and the instructions set out in
the operating manual.
Any functional disorders, especially those affecting the •
safety of the machine, must be rectified immediately.
The safety, working and maintenance instructions of •
the manufacturer as well as the dimensions given in the
chapter „Technical data“ must be adhered to.
The relevant accident prevention regulations and other, •
generally recognized safety-technical rules must also
be adhered to.
The machine may only be used, maintained, and oper-•
ated by persons familiar with it and instructed in its
operation and procedures.
Arbitrary alterations to the machine release the manu-•
facturer from all responsibility for any resulting dam-
ages.
The machine may only be used with original accesso-•
ries and original tools supplied by the manufacturer.
Any other use exceeds authorization. The manufacturer
To Next Page
Loading...
