Scheppach HC26 User Manual (English)

Other manuals for Scheppach HC26

Translation Of Original Instruction Manual96 pages

Questions and Answers:

W
William WagnerAug 3, 2025
What to do if my Scheppach HC26 Compressor does not start?
- K
  Kevin PeckAug 4, 2025
  If your Scheppach Compressor isn't starting, there could be several reasons. First, check the supply voltage, power plug, and socket-outlet to ensure they're working. Also, make sure the extension cable isn't too long and has adequately sized wires to provide sufficient voltage. Operating the compressor when the outside temperature is below +5° C can also prevent it from starting, so ensure it's warmer than that. Finally, the motor might be overheated; allow it to cool down and address the cause of the overheating.
J
jamiedeleonAug 8, 2025
Why does my Scheppach HC26 Compressor start but there is no pressure?
- J
  jimmy86Aug 8, 2025
  If your Scheppach Compressor starts but doesn't build pressure, it could be due to a few reasons. A leaking non-return valve could be the cause and should be replaced by a service center. Damaged seals can also cause this issue; have them checked and replaced, if necessary, by a service center. Additionally, check the drain plug for condensation water and tighten it by hand. Inspect the screw's seal and replace it if needed.
M
Melinda BrownAug 13, 2025
How to fix a Scheppach Compressor that starts but tools don't?
- J
  Jennifer EvansAug 14, 2025
  If your Scheppach Compressor starts and the pressure gauge shows pressure, but your tools aren't working, the issue might be with the connections. Check the compressed air hose and tools for leaks, and replace them if necessary. Also, inspect the quick-lock coupling for leaks and replace it if needed.
B
butlerryanAug 18, 2025
What to do if my Scheppach Air Compressor does not start?
- S
  Shannon AyersAug 18, 2025
  If your Scheppach Air Compressor isn't starting, several factors could be at play. First, check the supply voltage, power plug, and socket-outlet to ensure they're functioning correctly. Insufficient supply voltage could also be the culprit, so make sure your extension cable isn't too long and uses adequately sized wires. Another reason might be low outside temperature; avoid operating the compressor below +5° C. Lastly, the motor might be overheated; allow it to cool down and address the cause of overheating if necessary.