www.scheppach.com service@scheppach.com +(49)-08223-4002-99 +(49)-08223-4002-58
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
19 І GB
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of
waste equipment may have negative consequences
for the environment and human health due to poten-
tially hazardous substances that are often contained
in electrical and electronic equipment. By properly
disposing of this product, you are also contributing
to the effective use of natural resources. You can
obtain information on collection points for waste
equipment from your municipal administration, pub-
lic waste disposal authority, an authorised body for
the disposal of waste electrical and electronic equip-
ment or your waste disposal company.
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: belt, hose, lance, Nozzles and attach-
ments, air lter, seals
* Not necessarily included in the scope of delivery!
Cleaning the nozzle (Fig. 1)
Use the supplied wire (11) to clean clogged nozzles.
Disposal and recycling
The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The equip-
ment and its accessories are made of various types
of material, such as metal and plastic. Never place
defective equipment in your household refuse. The
equipment should be taken to a suitable collection
center for proper disposal. If you do not know the
whereabouts of such a collection point, you should
ask in your local council ofces.
Possible causes of failure
Troubleshooting Cause Remedy
Device does not work
No electrical voltage at the device.
Check the fuse, power cable and
power plug and have them replaced
by qualied personnel if necessary.
Cross section of the extension cable
not large enough and/or the exten-
sion cable is too long.
Use extension cables with larger
cross sections and/or use shorter
extension cables.
The mains voltage is lower than that
specied.
Contact the power supply company if
necessary.
The pump is frozen. Check and thaw if necessary.
The motor starts but there is no build
up of pressure
Air intake in the water inlet.
Check the supply hose and hose
connection and replace if necessary.
Discharge nozzle is too large. Check and replace if necessary.
Irregular operating pressure Air intake in the water inlet.
Check the supply hose and hose
connection and replace if necessary.
To Next Page
Loading...
Need help?
General
