www.scheppach.com
GB
|
31
m CAUTION!
The machine must be secured to the oor / countertop
using suitable screws / screw clamps since otherwise
there is a risk that it will tip over.
• Before you connect the equipment to the mains sup-
ply make sure that the data on the rating plate are
identical to the mains data.
• m WARNING! Before cleaning~, adjustment~,
maintenance~ or repair work, disconnect the power
cord from the main power supply!
• Check at regular intervals that the knife (25) is rmly
attached in the knife block.
• The knives (25) must not project more than a maxi-
mum of 1.1 mm out of the knife block.
• Make sure that the anti-kick claws (24) work correct-
ly.
• Always wear eye protection.
• Never cut concavities, tenons or shapes.
• All covers and safety devices have to be properly
tted before the machine is switched on.
• It must be possible for the planing knife to run freely.
m IMPORTANT!: The surfacing and thicknessing
plane has been specially designed for planing solid
wood. High alloy knives (25) are used for this purpose.
The contact surface of the workpiece must be at for
thicknessing. If you want to work on large or heavy
workpieces, the machine must be secured in place
(e.g. using the thread in the machine base).
• The ON/OFF switch (2) is on the left-hand side of
the machine. Press the green key “I” to switch on
the machine. Press the red key “0” to switch o the
machine.
• The machine is tted with an overload switch (1) to
protect the motor. In the event of an overload, the
machine will cut out automatically. After a short
time, the overload switch (1) can be reset again.
• To work on long workpieces, use roller tables or a
similar supporting arrangement. Such optional units
are available from your local DIY stores. They must
be placed at the entry and exit ends of the plane.
Their height must be adjusted such that the work-
piece is horizontal when it is fed into and out of the
machine.
• Anti-kick claws (g. 9 - pos. 20)
at least once per shift by a visual inspection to
establish that they are in good working order, for
example, that the contact surface has not been
damaged by impacts and that the anti-kick claws
(25) fall back without hindrance due to their own
weight;
• Planing blades (g. 17 - pos. 25)
for signs of damage and to ensure they are posi-
tioned correctly.
The machine may only be used if all these condi-
tions are satised.
Use only well sharpened and maintained blades. Use
only blades that are designed for the machine.
Use pusher wood or sticks which are in perfect condi-
tion for machining short workpieces.
Connect the machine to a dust and chip extractor.
Check that the stop is secure before starting the ma-
chining work.
Ensure that you can maintain your balance at all times.
Stand to the side of the machine.
Whilst the machine is running keep your hands at a
safe distance from the cutting block and from the point
at which the chips are discharged.
Do not start the planing work until the cutting block has
reached the required speed.
Also ensure that the workpiece does not contain any
cables, wires, cords or the like. Do not machine any
wood which has lots of knots or knot holes.
Secure long workpieces to prevent them tipping over
at the end of the planing process. Use roller stands, for
example, or similar devices for this purpose.
Removing sawdust and chippings from the machine
when running is strictly prohibited.
Switch o the machine immediately it is jams. Pull out
the mains plug and remove the jammed workpiece.
Set the smallest cutting size after use to prevent the
risk of injury.
To Next Page
Loading...
Need help?
General
