Scheppach HMS1080 User Manual

www.scheppach.com
36
|
GB
Too little work-
piece feed when
thicknessing
Workpiece has been processed
against the direction of growth
Clean the table top and treat it thinly with glide wax
Too much material planed o󰀨
at once
Repair the transport rollers
Chip ejection
clogged when
thicknessing
(without suction
system)
High degree of chip take-o󰀨 Reduce chip take-o󰀨
Blades are blunt Change blades
Wood is too wet Use a dry workpiece
Chip ejection
clogged when
planing (without
suction system)
High degree of chip take-o󰀨 Reduce chip take-o󰀨
Feed to high Reduce the feed speed
Blades are blunt Change blades
Wood is too wet Use a dry workpiece
Clogged chip
ejection with
suction system
when planing or
thicknessing
Chip extraction system is too
weak
A chip extraction system must be used, which guarantees
an air speed of at least 20 m/s at the suction connection
nozzle

Scheppach HMS1080 Specifications

General

Power	1500 W
Planing width	254 mm
Max planing depth	3 mm
Max thicknessing height	120 mm
Feed rate	8 m/min
Number of blades	2
Max. planing width	254 mm
Planer knives	2
Motor power	1500 W
Planer knife speed	8500 rpm