www.scheppach.com
24
|
GB
• Try to minimise stress from vibrations as low as
possible. Some examples of means for reducing the
vibration stress are wearing gloves while using the
tool and limiting work time. In the process all parts
of the operating cycle must be taken into account
(such as times in which the electric tool is switched
o or time in which it is switched on, but is not run-
ning under a load).
8. Unpacking
• Remove the concrete mixer from the box with two
people.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the expiry of the
warranty period.
• Familiarise yourself with the product by means of the
operating manual before using for the rst time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Replace-
ment parts can be obtained from your dealer.
• When ordering please provide our article number as
well as type and year of manufacture for your prod-
uct.
m WARNING!
The device and the packaging are not children‘s
toys!
There is a danger of choking
9. Assembly
m Attention!
The concrete mixer may only be used after complete
assembly.
1. )
On rear foot with wheel axle (11), t split pin, washer,
tyres (12), washer, split pin on both sides.
Slightly bend open the split pins after tting
• Furthermore, despite all precautions having been
met, some non-obvious residual risks may still re-
main.
• Residual risks can be minimised if the “Safety in-
structions” and the “Proper use” are observed along
with the operating instructions.
7. Technical data
MIX160 MIX180
Engine
230V / 50 Hz
0.65 kW
230V / 50Hz
0.80 kW
Capacity 160 l 180 l
Protection class IP45D IP45D
Dimensions
1280 x 840 x
1300 mm
1280 x 840 x
1340 mm
Weight 53,8 kg 56,5 kg
Sound pressure level
L
pA
70 dB(A) 68 dB(A)
Uncertainty K 2,8 dB(A) 5,2 dB(A)
Sound power level L
WA
93 dB(A) 93 dB(A)
Uncertainty K 2,8 dB(A) 5,2 dB(A)
Information about noise development
Warning: Noise can have serious eects on your
health. If the machine noise exceeds 85 dB (A), please
wear suitable hearing protection. If the electrical con-
nection is defective, the power can fail when starting
the machine. This could inuence other machines (e.g.
blinking lamps). If the electrical power corresponds to
Zmax < 0.27, such disruptions should not occur. (How-
ever, if they do, inform your specialist dealer).
• The specied vibration emission value has been
measured according to a standardised testing pro-
cedure and can be used for comparison of one elec-
tric tool with another;
• The specied vibration emission value can also be
used for an initial assessment of the load.
Warning:
• The vibration emission value can vary from the
specied value during the actual use of the electric
tool, depending on the type and the manner in which
the electric tool is used;
To Next Page
Loading...
Need help?
General
