www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
53
Fault Possible cause Remedy
Loud while running, ma-
chine vibrates heavily
• Screws are loose
• Blade fasteners are loose
• Blade is unbalanced
• V-belt damaged.
• Discharge chute blocked.
• Check screws
• Check blade fasteners
• Replace blade
• Replace V-belt.
• Clean discharge chute.
Engine does not start
• Incorrect start sequence
• Choke setting incorrect
• Brake lever not pressed
• Speed lever in wrong position
• Spark plug is defective
• Fuel tank is empty
• Bowden cables too long
• poor fuel, storage without empty-
ing the petrol tank, incorrect
petrol type
• spark plug fouled (carbon residue
on the electrodes), electrode
distance too large
• The spark plug is wet from the
petrol (motor ooded).
• Engine faulty
• Check start process
• Check choke setting
• Press brake lever
• Check setting
• Replace spark plug
• Rell with fuel
• Adjust the Bowden cables using the union nuts.
• Empty the fuel tank and carburettor. Fill with fresh
fuel.
• Clean the plug, check the heat value of the plug,
replace the spark plug as required, set to 0.6 - 0.8
mm
• Dry the spark plug and insert it again.
• Contact authorised customer service
Engine overheating.
• Dirty cooling ribs.
• Engine oil level too low.
• V-belt worn.
• Clean cooling ribs.
• Check the engine oil level and top up the engine oil
if necessary.
• Replace the V-belt.
Machine does not drive.
• Gearbox disengaged.
• V-belt (gearbox) detached.
• V-belt (gearbox) worn or defec-
tive.
• Missing feather key between rear
axle and rear wheels.
• Engage the gearbox (freewheel lever).
• Fit V-belt (gearbox).
• Replace V-belt (gearbox).
• Install feather key.
Engine runs unsteadily
• Air lter is soiled
• Spark plug is soiled
• Clean the air lter
• Clean the spark plug
Poor cut, lawn turns
yellow after mowing.
• Blade is blunt
• Cutting height is too low
• Sharpen the blade
• Set correct height
The discharge of grass
clippings is unclean
• Cutting height is too low
• Blade is worn
• Basket is clogged
• Chute blocked
• Grass too wet
• Driving speed too high
• Set correct height
• Replace the blade
• Empty the basket
• Clean the ejector chute
• Mow during dry weather
• Choose a lower gear
The mower does not
start with the electrical
start
• Battery has discharged
• Fuse burnt out
• Charge the battery
• Replace the fuse
Motor output drops dur-
ing mowing
• The driving speed in relation to
the cutting height is too high
• Reduce the driving speed and increase the cutting
height
Braking power insuf-
cient
• The brake is no longer set cor-
rectly
• Contact the specialist merchant/customer service
To Next Page
Loading...
Need help?
General
