www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
GB
|
29
zone of cutting blade.
• When the engine is running, press the drive lever
(2) to the handle (1) in order to engage drive on the
mower.
•
this operation several times in order to ensure that
m WARNING
Whenever you need to perform any kind of ad-
justment and/or repair work on your lawn mower,
wait until the blade has come to a complete stop.
Warning! Danger of injury due to moving danger-
ous parts!
Always switch o the engine before carrying out
any adjustments, maintenance or repairs.
m Note!
Using the drive:
• Engine brake lever (3): Use the lever to stop the
• To mow, hold the engine brake lever (3) in the work-
start/stop lever several times to be sure that it is
• Drive lever (2):
closed and the lawn mower will start to move with
the motor running. Release the drive lever in good
time to stop the moving lawn mower. Practice start-
mower.
Caution: The blade begins to rotate as soon as the
engine is started.
Important:
motor brake several times to be sure that the stop
Note: -
timal for cutting and blowing grass into the basket and
• Check the oil level.
•
up to the lower point of the tank inlet with about 0.8
litres of petrol. Use a funnel and a measuring con-
clean unleaded fuel.
its freshness.
m WARNING
-
the engine before refueling and allow the engine to
cool down for a few minutes.
Start engine (Fig. 14)
• Ensure that the ignition cable is connected to the
spark plug.
• Stand behind the mower. One hand squeezes the
engine brake lever (3) to the handle (1), the other
pulls the pull start.
• Start the engine using the reversing starter (17). To
feel a resistance) and then start the engine with a
sharp pull. If the engine does not start, pull the han-
dle again.
• Due to protective coating on the engine, a small
use of the product and should be considered nor-
mal.
Note: Easier starting in colder temperatures by
pressing the primer (Fig. 15/ 8). Use only by a cold
engine!
m CAUTION!
• Never allow the starter cord to snap back.
• -
peat the starting process several times.
Turn o the engine:
•
then the engine brake lever (3) and wait for the
blades to stop.
• Pull the spark plug boot from the spark plug (10)
boot in order to prevent the engine from restarting.
•
cord for the engine brake. Check that the cord is
should be replaced.
Before mowing
Important information
•
wear sandals or tennis shoes.
• Inspect the blade. A blade that is bent or damaged
for a genuine replacement blade.
•
• Read and follow in the instructions in the operating
manual as well as the information regarding the
users of the machine.
To Next Page
Loading...
