EasyManua.ls Logo

Scheppach MS132-42

Scheppach MS132-42
120 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
www.scheppach.com / service@scheppach.com / +(49)-08223-4002-99 / +(49)-08223-4002-58
32
|
GB
Changing the oil

the season when the engine is warm.



volume 1 Liter).
Remove the dipstick and tip over the mower untill

Fill up with engine oil as far as the top mark on the
dipstick (approx. 0,4 l).
Important! Do not screw in the oil dipstick to check

Dispose of the used oil in accordance with applicable
regulations.
Cleaning the belts (Fig. 17, 19)
-
ing the screws out.
Clean the elements of the transmission and the belt

Screw the transmission housing and the knife on
again.
Care and adjustment of the cables


Maintenance of the air lter (Fig. 20)

engine because it will prevent enough air getting to
the carburetor. It is therefore imperative that regular
        

-


    

-
     

Maintenance of the spark plug (Fig. 21)
Check the spark plug for dirt and grime after 10 hours

wire brush. Thereafter service the spark plug after

󰀨
spark plug (10) with a spark plug wrench.
Using a feeler gauge, set the gap to 0.75 mm( 0.030”).

Wheel axles and wheel hubs

Blade
    
-
thorized service workshop. For optimum results it is
recommended that the blade should be inspected

Changing the blade (Fig. 17)

blade replaced.
Wear gloves when replacing the blade in order to pre-



To replace the blade, undo the screw.
Reinstall as illustrated in Fig. 17. Tighten the screw
 When replacing
the blade, the blade screw should also be replaced.
Damaged blades
Should the blade, in spite of all precautions, come
into contact with an obstruction, shut down the en-
        
the lawn mower onto its side and check the blade for
damage. Damaged or bent blades must be replaced.
Never attempt to bend a bent blade back to straight
         
worn blade as this will cause vibrations and can lead
to further damage to the lawn mower.
m CAUTION!
a damaged blade.
Resharpening the blade

order to avoid imbalance, the blade should be re-

Checking the oil level
m CAUTION! Never run the engine with no or too lit-
tle oil. This could cause severe damage to the engine.

Checking the oil level (Fig. 18):

-
wise, pull out and wipe. Insert the dip stick back in

back in.
󰀨

be between the maximum and the minimum

Table of Contents

Related product manuals