www.scheppach.com
36
|
GB
15. Troubleshooting
Troubleshooting
The table shows potential failures, their possible cause and removal options. However, if you are unable to remove the
problem, contact a professional to assist you.
m CAUTION!
m CAUTION!
If, after making an adjustment or repair to the engine, you let it run for a few minutes, remember that the exhaust and other
parts will get hot. Thus, do not touch parts that emanate heat, as these may burn you.
Important hint in case of sending the equipment to a service station:
Due to security reasons please see to it that the equipment is sent back free of oil and gas!
Fault Possible cause Remedy
Loud while running, ma-
chine vibrates heavily
Screws are loose Check screws
Blade fasteners are loose Check blade fasteners
Blade is unbalanced Replace blade
Engine does not start
Brake lever not pressed Press brake lever
Speed lever in wrong position Check setting
Spark plug is defective Replace spark plug
Fuel tank is empty
Contaminated fuel
Cold environment Push the primer button (if present)
Engine faulty Contact authorised customer service
Engine runs unsteadily
Spark plug is soiled Clean the spark plug
Uneven mowing results
Blade is blunt Sharpen the blade
Cutting height is too low Set correct height
Unsatisfactory bagging of
the grass
Cutting height is too low Set correct height
Blade is worn Replace the blade
Basket is clogged Empty the basket
To Next Page
Loading...
Need help?
General
