www.scheppach.com
GB
|
27
Brush cutter / Cutter blade
•
the blade rotation direction needs be same as be-
tighten nut counter-clockwise, ensure the nut is
tightened enough.
•
m Warning!
Please make sure the cutting head has been assem-
Note:
materials. Dispose of packaging materials in accord-
ance with regulations.
5. Fit the belt. Fig. 17 - 21
•
OPERATION
When working with the equipment, the appropriate
plastic guard hood for cutting blade mode or cutting
The integrated blade in the cutting line guard hood
Filling with fuel
m Danger of injury! Fuel is explosive!
Turn o and cool the motor down before lling
the tank with fuel. You must observe all safety
instructions relating to handing fuel.
m Risk of device damage!
The device is supplied without motor or gearbox
oil.
ATTENTION! Before operating, you must ll it
with fuel.
•
•
•
Draining fuel. Fig. 40
• Hold a collection container beneath the fuel drain
bolt.
• Unscrew the tank cap and remove it.
•
•
Start on the unit
-
sembled.
m Danger of injury!
Do not operate the device unless you did not
nd any faults. If a part has become defective,
make sure to replace it before you use the device
again.
Check before use!
• Check the safe condition of the device:
• Check the device for leaks.
• Check the device for visual defects.
• Check that all parts of the device have been se-
• -
tion.
m Danger of injury!
-
Start Fig. 21 - 27 + 41
Choke lever:
Warm engine / choke closed:
Cold engine / choke open:
engine as follow:
1. Set the equipment down on a hard, level surface.
2.
3.
4.
5. Pull the recoil starter handle 3-5 times to start the
6.
7. Wait a little while and then close the choke lever
8. When the engine is running and idling. The throt-
lock the throttle lever (8) press the throttle lever
9. Adjusting line length when working:
To release more line, tap the cutting line head
against the round with engine at top speed: the
10.
stop cutting head working, release the throttle le-
To Next Page
Loading...
