www.scheppach.com
26
|
GB
•
•
• Wear gloves.
In these operating instructions we have marked
the places that have to do with your safety with
this sign: m
7. Before starting the equipment
Each time before use, check the following:
•
• That the equipment is in perfect condition and that
-
plete.
•
•
1. Fuel and oil
Recommended fuels
in the fuel mixing table.
Important: Do not use a fuel mixture which has been
Important: Never use 2-stroke oil with a recommend-
ed mixing ratio of 100:1. The manufacturer’s war-
to inadequate lubrication.
-
proved for the purpose to transport and store fuel.
Pour the correct quantities of petrol and 2-stroke oil
into the mixing bottle (see scale printed on the bot-
tle). Then shake the bottle well.
-
haust part blocking or piston ring sticking.
-
remained fuel into an airtight container and keep it in
the dark and cool room.
2. Fuel mixing table
Example:
1 l Petrol : 0,025 l 2-stroke oil
5 l Petrol : 0,125 l 2-stroke oil
Warning!
Take care of the emission of exhaust gases.
Always shut o engine before fuelling. Never add
fuel to a machine with a running or hot engine.
Take care of re!
8. Attachment and operation
ASSEMBLY
When assembling this machine, please follow the
1. Assemble the handle on the machine. Fig. 4 -6
•
right and left handle on the centre of handle holder.
• Last assemble the handle holder and tighten the
inner screws enough.
2. Mounting the shaft. Fig. 7
• Push the lower part of the shaft (b) right down until
the stop pin (a) slots into the hole (c) in the shaft.
•
3. Assemble the safe guard. Fig. 11 13
• -
closed as standard accessories for tighting the
nuts enough. Please see the below pictures show-
ing.
m Warning! -
-
ure to do so can cause poor performance, possible
machine without the guard assembled!
4. Assemble and disassemble the cutting head
grass trimmer / nylon cutting head. Fig. 14 - 15
• Release the nut.
turn the socket wrench clockwise, the nut will be
released.
•
Remove another shield after release the nut. Still
-
•
To Next Page
Loading...
