www.scheppach.com
30
|
GB
5 Add one teaspoon of 2-stroke engine oil into the
Note:
Putting the equipment back into operation
1 Remove the spark plug (see section 10 Change
and clean the spark plug).
2
oil from the combustion chamber.
3 Clean the spark plug and check that the electrode
gap is correct, or insert a new spark plug with the
correct electrode gap.
4 Prepare the equipment for operation.
5
Transport
described in section 8 draining fuel. Clean coarse dirt
12. Disposal and recycling
Notes for packaging
The packaging materials are
packaging in an environmen-
You can nd out how to dispose of the disused
device from your local authority or city adminis-
tration.
Fuels and oils
• Before disposing of the unit, the fuel tank and the
engine oil tank must be emptied!
•
waste or drains, but must be collected or disposed
•
Important hint in case of sending the equipment
to a service station:
equipment is sent back free of oil and gas!
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Line spool, cutting blade, spark plug, air
Spare parts and accessories can be obtained from
our service centre. To do this, scan the QR code on
the cover page.
11. Cleaning and storage
Cleaning
• -
cure hold.
• Clean the equipment as required with a damp cloth
m Important!
• -
• Never immerse the equipment in water or other liq-
uids in order to clean it.
•
the reach of children.
Storage
Important: Never put the equipment into storage for
-
ing steps.
Storing the equipment
Otherwise the fuel still remaining in the carburetor will
cause problems when starting up the equipment and
1
-
2 To remove the fuel from the carburetor, start the
engine and let it run until the equipment stops.
3 Leave the engine to cool (approx. 5 minutes).
4 Remove the spark plug (see section 10 Change
and clean the spark plug).
To Next Page
Loading...
