www.scheppach.com
34
|
GB
13.3 Software update (Fig. 28)
m NOTE The robot must be connected to the
WiFi in order to perform an automatic software
update via the app.
Connect your robot to your WiFi.
The software can be updated as soon as a new ver-
sion is available. (The latest software version can be
found on our homepage.
The software can be installed via USB or the app.
The software for USB transmission can be download-
ed from our homepage www.scheppach.com.
13.3.1 Software update via USB
• Look for the latest software version on our home-
page.
• Download this to an empty FAT32 formatted disk.
• Remove the rechargeable battery covering as de-
scribed in 13.2.
• Insert the data carrier into the USB drive (Fig. 28).
• Switch on the mower by pressing the button
(“POWER ON/OFF” button).
• The update starts automatically.
• Wait until “OK” appears on the display and then re-
move the data carrier.
• Re-attach the rechargeable battery covering as de-
scribed in 13.2.
m NOTE
The operating manual supplied with your robot mow-
er (1) is based on the software version at the time of
production of the mower.
Some new or changed features and functions may
not be included in the operating manual.
You can nd the latest version of the software in the
app or at www.scheppach.com.
Service information
With this product, it is necessary to note that the fol-
lowing parts are subject to natural or usage-related
wear, or that the following parts are required as con-
sumables.
Wearing parts*: Blade (7), screws (8), boundary wire
(11), wire pegs (12).
* may not be included in the scope of supply!
Article number(s) for wear parts:
Item 7 Blade 7913001601
Item 8 Screws 3913001001
Item 11 Boundary wire 7913001702
Item 12 Wire pegs 7913001701
m ATTENTION
Put on protective gloves before replacing the blade
(7).
m ATTENTION
All blades (7) must always be changed at the same
time. The changing of individual blades (7) is not per-
mitted.
If the Phillips screws (8) are damaged or can no
longer be tightened, these must also be replaced.
New screws are included with the replacement blades.
• To replace the blades (7), place the robot mower (1)
on a workbench with the underside facing upwards.
(We recommend a soft base to avoid damage to
the housing).
• Loosen the Phillips screw (8) with the help of a
Phillips screwdriver (not included in the scope of
delivery).
• Remove the old blade (7).
• Fit the new blade (7) and fasten it with a new screw
(8).
• Check that the blade (7) can move.
If this is not the case, loosen the screw (8) a little.
• Carry out this operation on all three blades (7).
13.2 Inserting/removing the rechargeable battery
(Fig. 26/27)
m ATTENTION
Switch the mower o before starting with the work.
• To install/remove the rechargeable battery, place
the robot mower (1) on a workbench with the under-
side facing upwards. (We recommend a soft base to
avoid damage to the housing).
• Remove the battery cover screws and remove the
battery cover (Fig. 26/27).
• Remove the rechargeable battery retaining device.
• Pull the rechargeable battery out carefully.
m NOTE Do not pull on the cables.
• Loosen the locking and pull the connector o.
• Insert the rechargeable battery (if necessary a new
original rechargeable battery).
• Re-install the rechargeable battery in reverse order
(Fig. 26/27).
To Next Page
Loading...
Need help?
General
