• Follow all charging instructions and never charge the battery or rechargeable tool outside
the temperature range specified in the operating manual. Incorrect charging or charging out-
side the approved temperature range can destroy the battery and increase the risk of fire.
• Before commissioning, ensure that the mains voltage matches with the operating voltage on the
type plate.
Service
• Never attempt to service damaged batteries. Any type of battery maintenance shall be carried
out only by the manufacturer or an authorised customer service centre.
Special safety instructions for battery-powered devices
ATTENTION
Observe the safety instructions and notes in the operating instructions of all compatible products
you use.
• Make sure the device is switched off before inserting the battery. Inserting a battery into an
electric tool that is switched on can cause accidents.
• Only charge your batteries indoors because the battery charger is only intended for this
purpose. Danger due to electric shock.
• To reduce the risk of electric shock, unplug the battery charger from the wall socket be-
fore cleaning.
• Do not expose the battery to strong sunlight for a long time and do not place it on radia-
tors. Heat damages the battery and there is a risk of explosion.
• Allow a heated battery to cool down before charging.
• Do not open the battery and avoid mechanical damage to the rechargeable battery. There
is a risk of short-circuiting and vapours may escape that irritate the respiratory tract. Make sure
you get fresh air and seek additional medical help.
• Do not use accessories that are not recommended by the manufacturer. This can lead to
electric shock or fire.
6 Technical data
Battery charger SBC2.4A
Input
Measured voltage 230 – 240 V~
50 Hz
Rated power consumption 65 W
Fuse (internal) 3.15 A
Output
Rated voltage
21.5 V
Rated current 2.4 A
Protection class II (Double insulation)
Battery (Li-Ion) SBP2.0
Number of battery cells 5
20 | GB www.scheppach.com
To Next Page
Loading...