4
6 Partly install the key cylinder.
Turn key cylinder into the chassis. Tighten just enough to
secure outside trim. Insert key, then pull out one notch to aid
with turning.
NOTICE
Do not tighten more
than six full turns!
Tighten fully at step 12!
7 Install inside spindle, spring cage, and mounting plate.
Arrow on the mounting plate faces in direction of lever down
rotation.
INTERIOR
NOTICE
Arrows in
direction of lever
down rotation.
8 Install the inside rose and lever.
*included in box
9 Connect the cables to the inside assembly.
There are two cables that need to be connected.
Cable slack
should be folded
downward.
10 Deadbolt (LEMD) Only: Align driver bar into the
chassis.
Thumbturn should be vertical when deadbolt is retracted.
11 Install the inside assembly.
Actual Size
To Next Page
