Schlage LE - Page 3

3
Installation Instructions for Sectional Trim
Continue for installation
instructions for your lock with
sectional trim (Greenwich).
For
escutcheon
(Addison) trim
instructions
go to page 6.
1 Install chassis.
Route chassis connector through the upper 5/8” hole on the
interior side of the door, and pull through the slack as you
slide chassis into mortise. You may use needle-nose pliers to
gently pull the cable through the hole.
CAUTION
Start screws
but don’t fully
tighten until
Step 12!
INTERIOR
Hole
2 Install lever spindle on the exterior side of the door.
Install spring on lever spindle.
EXTERIOR
3 Install spring cage into lever.
Use pliers carefully to install mounting posts to avoid damage.
Fully tighten mounting
posts on screws.
IMPORTANT
Arrows in direction
of lever down
rotation.
4 Install outside lever.
EXTERIOR
5 Install the outside trim and route wire all the way through
the hole to the interior side of door.
Route wire from
outside trim above
wire from the chassis.
EXTERIOR