11
•
To store the actuator at temperatures below of –30°C and up to +70°C, it is necessary to carry out
additional checks and tests from time to time, depending on the ambient conditions.
Preservation conditions
The procedures that must be performed to the equipment during storage to assure proper operation of
the equipment after installation are the following:
•
Place the actuators on a wood surface pallet so as to prevent direct contact with the ground.
•
Protect all unpainted parts with grease.
Note :
Before installing the actuator, perform one complete operation (opening and closing) to
verify it strokes properly.
To Next Page
Loading...
Need help?
General