10
II. RECEIVING,STORAGE AND HANDLING
A. Preliminary Verification Upon Receipt of Material
Warning:
At receipt of the material:
1.
Check the completeness of the supply, by referring to the packing list;
2.
Check the tag number, serial number and technical information in the nameplate with reference to the
order acknowledgement.
3.
The actuators are delivered with plugged connections. Which must remain plugged if not utilized or must
be re-plugged with the relevant plug or reconnected after any testing operation.
4.
Carry out a preliminary verification in order to ensure:
•
The integrity of the material and the absence of damages;
•
The integrity of the painting. If necessary, carry out the paint touch up, by following the instructions
of the painting specification (please refer to the technical documentation);
•
The presence of the plugs on all the pneumatic and (where present) electric connections.
B. Storage and Preservation
Warning:
If the storage of the actuator is necessary, please follow these instructions.
Storage conditions
The actuator must be stored in a warehouse adequately protected against harmful environment.
The recommended ambient temperature is : Minimum - 20°C / Maximum 70°C
Relative Humidity : Maximum + 90%
Indoor storage
•
Restore the paintwork of the components that have been damaged during transport
•
Place the actuators on a wood surface pallet so as to prevent direct contact with the
ground.
•
Keep the electric components(where present) perfectly dry.
Outdoor storage
•
Restore the paintwork of the components that have been damaged during transport
•
Place the actuators above the ground level.
To Next Page
Loading...
Need help?
General