7
H. Safety of the Power Supply Connection (If Applicable)
Before carrying out any operation on the actuator, check that the power supply is off.
Before connecting the actuator:
• Verify the absence of the power supply and always connect the ground cable to the actuator first.
• Check that the power supply line characteristics are in accordance with the nameplate and
installation manual data.
I. Safety Recommendations
Check that the ground resistance complies with the limits allowed by the National Laws relevant to the
country where the actuator is installed.
If the actuator is stored/installed in a hazardous area, do not use open flames and/or devices that could
cause sparks.
At the end of any intervention on the actuator please check that all the boxes and covers are properly
closed.
The operators assigned to the actuator's maintenance must be authorized personnel or otherwise must
have attended a training course dedicated to the use and maintenance of the actuator.
J. Electrostatic Discharges Prevention
The actuator handling must be carried out using the handling ring supplied with the actuator. In order to
prevent the electro-static charges storage, attention must be paid during the cleaning of any external
component made from plastic material.
The plastic material must be cleaned only with a damp cloth or with antistatic products.
To Next Page
Loading...
Need help?
General