37
Elevator positioning system USP 30 / 100
Table of contents Page
Introduction 38
General information 38
Exclusion of liability 38
The manufacturer 38
Concerning your personal safety 39
System components 40
Functioning of the system 40
Appropriate use 40
Installation – an overview 41
Electromagnetic Compatibility (EMC) 42
Installation of the USP 42
Tools required for installation 42
Location 42
Preparations for installation 43
Installation of the receiver in the shaft head 43
Mounting the signal wire 45
Cutting the signal wire to length 46
Test drive 50
Maintenance 50
Mounting the signal wire 53
Cutting the signal wire to length 54
Test drive 58
Maintenance 58
Installation of the correction sensor and the actuating
magnets for the USP 100 system 59
Installation of the correction sensor 59
Installation of the actuating magnets 60
Initialisation drive with the USP 100 system 61
Circuit diagrams 62
Technical data 63
Trouble Shooting USP Installation 65
Other possible causes of failure 68
Final remarks for trouble shooting 69
Note 70
USP_Montage_GB.indd 37 18.02.2013 15:39:42
To Next Page
Loading...