schmersal USP 30 - Page 49

49
Elevator positioning system USP 30 / 100
Mount the transmitter under or above the link. Align the trans-
mitter so that the signal wire is centred in the transmitter coil.
Connect the 15-pin sub-D plug at the receiver, and the round
M12 plug to the transmitter and apply the cable of the sender
in the cabin terminal box to the trailing cable.
The technical data provides the pin assignment
of the plug.
15
16
USP_Montage_GB.indd 49 18.02.2013 15:39:45