34
INSTALLATION NECKROLL
1. Insert the piping on one side.
2. Position the piping all the way around in
the closing edge.
3. Insert the piping on the other side in.
4. Pull the cheek pad a little inwards and
and fasten the hooks on the right and left
side.
Note:
Ensure that the Anti Roll-O System straps are not twisted.
Caution:
Never ride when parts of the inner lining have been removed.
Caution:
Excessive heat (e.g. exhaust heat) can cause damage to the inner lining!
Caution:
To avoid damage to the inner EPS lining and inner shell, do not hang the
helmet over the mirrors or handlebar grips or anything else.
C. THE HELMET
To Next Page
Loading...
