Schumacher Electric XP400 User Manual (English)

Questions and Answers:

K
Kimberly MartinezJul 31, 2025
What to do if my Schumacher Electric Remote Starter won't jump start my car?
- S
  Sabrina RobertsJul 31, 2025
  If your Schumacher Electric Remote Starter isn't jump starting your car, there might be a few reasons: * The connections could be reversed. Disconnect the Remote Starter and reverse the clips. * The Remote Starter's battery might not be charged. Check the battery charge status by pressing the button on the front. * The clips may not be making a good connection. Check the connection to the battery and frame, ensure the points are clean, and rock the clips back and forth. * The vehicle's battery might be defective. In this case, have the battery checked.
D
Deborah PhillipsAug 5, 2025
Why won't my Schumacher Electric XP400 Remote Starter power my 12V device?
- C
  Christopher ByrdAug 5, 2025
  If your Schumacher Electric Remote Starter isn't powering your 12V device, consider these possibilities: * The 12V device might not be turned on. Ensure it is switched on. * The Remote Starter's battery may not be charged. Check the battery charge status by pressing the button on the front. * The 12V device could be drawing more than 15A or has a short circuit. Disconnect the 12V device; the internal breaker will automatically reset after a minute or two. Try the device again, and if it happens again, consider replacing the 12V device.
L
logankristinAug 9, 2025
What to do if Schumacher Electric Remote Starter won't jump start my car?
- J
  James CampbellAug 9, 2025
  If your Schumacher Electric Remote Starter isn't jump starting your car, several issues could be the cause. First, ensure the connections aren't reversed by disconnecting the Instant Power and reversing the clamps. Next, check the battery status by pressing the Battery Status button; if the battery is low, it needs charging. It's also possible that your vehicle's battery is defective and needs to be checked. For model XP750C, make sure the Instant Power is turned on. Finally, check the clamps for a good connection to both the battery and frame, ensuring the connection points are clean.
C
Cheryl SharpAug 15, 2025
Why Schumacher Electric XP400 Remote Starter won't power my 12V device?
- D
  Dr. Corey KnappAug 15, 2025
  If your Schumacher Electric Remote Starter isn't powering your 12V device, there are a few potential reasons. Begin by ensuring the 12V device is switched on. Then, check the Remote Starter's battery charge by pressing the Battery Status button. If the charge is low, recharge the unit. Also, the 12V device might draw more than 15A or have a short circuit; in this case, disconnect the device and allow the internal breaker to reset automatically (this should take a minute or two), then try the device again.
S
Steven WilkinsAug 19, 2025
What to do if Schumacher Electric XP400 Remote Starter compressor shuts off?
- S
  scottortegaAug 19, 2025
  If the compressor on your Schumacher Electric Remote Starter shuts off, it likely overheated. Allow it to cool down for a few minutes before trying to use it again.
V
vburnsAug 25, 2025
How to fix Schumacher Electric Remote Starter battery that won't hold a charge?
- C
  Christine WilsonAug 25, 2025
  If the battery in your Schumacher Electric Remote Starter won't hold a charge, the battery may be bad and unable to accept a charge. Have the battery checked.

Schumacher Electric XP400 Specifications

General

Model	XP400
Peak Amps	800A
Battery Type	Lithium Ion
Weight	2.1 lb
Dimensions	7.87" x 3.54" x 1.57"
LED Indicator	Yes
Voltage	12V
Type	Jump Starter
Battery Compatibility	12V batteries